Sopwith Baby

Parts chaos

30/07/2023It turns out that the consignment from Gardermoen probably contained parts for three different aircraft. Using 1:1 scale drawings, Gunnar is sorting out the parts that are to be used for the Sopwith Baby..

Production of wing parts.

08/10/2023The ribs are made from first-class birch plywood, and the strips from what the Americans call "spruce", which is knot-free Sitka spruce. When the spruce is allowed to grow densely it loses its branches and only the top stays green. This means it grows slowly and becomes dense, strong and free of knots.

Wing ribs, the final sprint

08/10/2023Gunnar expects to be finished with the rib production within a couple of days.

Work on the wings continues

23/07/2024A tissue is needed for the covering. It could be made from cotton, linen or some variant of artificial fiber. On the Sopwit Baby, there must be linen attached along the edges and to the ribs. To tighten the cloth, layers of dope are applied. It looks like a clear varnish that shrinks when it dries. The original nitrate dope is hard to find. We had some left over from previous projects, but we need more. Gunnar has to order it from a company in the USA. The consignment must go by boat due to the risk of fire and explosion. In the worst case, the shipment has to be kept in a small special container during transport.

Trial assembly of the wings.

01/08/2024At last the job of building the Sopwith Baby has come far enough that the wings with control surfaces can be trial-assembled. Trial assemblies have been done along the way as a check of the individual parts, but this is the first time everything is put together as one unit. Suddenly it looks like an aeroplane, one of Norway's first fighter aircraft.

Gunnar Koch and Rolf Liland on the Sopwith Baby

02/08/2024What was supposed to be an easy project to finish because so much had been done in advance turned out to be something quite different when it came to it. There was a lot of work left to complete parts and parts that were missing, both on the fuselage and the engine.

Balancing rudders, water rudder and engine mount.

14/09/2024The balancing rudders are identical top and bottom. With regard to side placement they are mirrored. This means that the same drawing can be used for all four rudders. The water rudder is placed at the very back of the tail, and is used for control when the aircraft moves about on the water.

Split fuselage

08/10/2024The fuselage consists of a rear part and a front part that can easily be separated from each other. The division runs behind the petrol tank. An ingenious way of building an aircraft. The solution saved space when the aircraft was to be shipped by boat. When the aircraft was to be used, it was assembled on deck and put onto the water using a crane. The reverse procedure applied when the mission was completed. If one part was damaged while there was still hope for the other, a swap could be made quite quickly.

New fuel and oil tanks

14/11/2024An elongated, round petrol tank came with the parts we received. It was very well made, and is placed behind the pilot's seat. Between the instrument panel and the firewall there are to be two more petrol tanks and an oil tank. These have now gone into production together with the associated parts.