Balancing rudders, water rudder and engine mount.

The balancing rudders are identical top and bottom. With regard to side placement they are mirrored. This means that the same drawing can be used for all four rudders. The water rudder is placed at the very back of the tail, and is used for control when the aircraft moves about on the water.

14 September 2024
14/09/2024
13:09
Arvid Martinussen

.......

© Arvid Martinussen (AM)
The first balancing rudder ready for covering
The first balancing rudder ready for covering
© AM
All four balancing rudders are identical.
All four balancing rudders are identical.
© AM
The dope is expected to be delivered at the turn of the month September/October, so in a couple of days.
The dope is expected to be delivered at the turn of the month September/October, so in a couple of days.
© AM
Balancing rudder with hinges fitted.
Balancing rudder with hinges fitted.
© AM
Parts of the engine mount. This is also a press mould. The pressing work will be done at Maskinering AS.
Parts of the engine mount. This is also a press mould. The pressing work will be done at Maskinering AS.
© AM
There are two sides that are mirrored. Here the sheet metal to be pressed is laid in place.
There are two sides that are mirrored. Here the sheet metal to be pressed is laid in place.
© AM
Bellcrank for the water rudder that sits on the tail of the aircraft. Ketil has both the patience and the knowledge needed to make such small details.
Bellcrank for the water rudder that sits on the tail of the aircraft. Ketil has both the patience and the knowledge needed to make such small details.
© AM
The water rudder is attached to the tail of the aircraft by means of this slender mechanism.
The water rudder is attached to the tail of the aircraft by means of this slender mechanism.
© AM
Bellcrank, rudder post and fittings.
Bellcrank, rudder post and fittings.
© AM
The fitting and the rudder mechanism look rather slender, but then the speed is quite moderate and the loads accordingly..
The fitting and the rudder mechanism look rather slender, but then the speed is quite moderate and the loads accordingly..
© AM
The fitting threaded onto the rudder post. The three holes are to make the part lighter.
The fitting threaded onto the rudder post. The three holes are to make the part lighter.
© AM
Part of an original instrument panel that we are going to copy.
Part of an original instrument panel that we are going to copy.
© AM
The instrument panel is on loan from Dag Bjørnar Mjelde at Tellevik Kystfort, a small local museum.
 The instrument panel is on loan from Dag Bjørnar Mjelde at Tellevik Kystfort, a small local museum.
© AM
This glass shows whether the oil pump is doing its job when the engine is run.
This glass shows whether the oil pump is doing its job when the engine is run.
© AM
Ketil has for a moment let go of the wheel to have a cup of coffee.
Ketil has for a moment let go of the wheel to have a cup of coffee.
© AM
Lots of cables and other "mess" in the area of the engine mount and firewall
Lots of cables and other "mess" in the area of the engine mount and firewall
© AM
Round hole is for the crankshaft
Round hole is for the crankshaft
© AM
The oval holes are to create profiles that reinforce and brace while reducing weight.
The oval holes are to create profiles that reinforce and brace while reducing weight.
© AM
© AM
Front and rear engine mount. Really slender things, but it has turned out that they hold.
Front and rear engine mount. Really slender things, but it has turned out that they hold.