The Fabric Covering Has Begun

The project has now come so far that the fabric is to be put in place. It must be cut to size and laid as tightly as possible over the surfaces to be covered. It is then sewn to the structure, which is what Gunnar is doing in the video, before dope is applied. This is work that takes time, and where sloppiness shows immediately in the form of wrinkles.

04.09
04/09/2025
23:29
Arvid Martinussen

The project has now progressed to the stage where the fabric must be precisely put in place. The cloth needs to be cut accurately to fit, then stretched as tightly as possible over the designated surfaces. Once positioned, it is carefully sewn to the underlying structure, as demonstrated by Gunnar in the video. Afterward, dope is applied to the fabric. This stage requires patience and attention to detail, as any lack of care will quickly reveal itself through visible wrinkles.

Video: The fabric is attached with needle and thread.

Click on the pictures

© Arvid Martinussen (AAM)
4.09: The fabric is sewn together by hand with needle and thread.
4.09: The fabric is sewn together by hand with needle and thread.
© AM
04.09: The blue tape does the job of holding the fabric in place until it has all been sewn together.
04.09: The blue tape does the job of holding the fabric in place until it has all been sewn together.
© AM
04.09: The rate of progress is one balancer rudder fully sewn per day
04.09: The rate of progress is one balancer rudder fully sewn per day
© AM
04.09: The steel tubes that form part of the wing structures are wrapped in linen tape before sewing.
04.09: The steel tubes that form part of the wing structures are wrapped in linen tape before sewing.